Sparklear™
Our in-house formulated pool treatment programme — precision chemistry, not guesswork. KKM-compliant water in 3–6 hours, documented on every visit.
Not a Product.
A Programme.
Sparklear™ is not a single bottle of chemical. It is Bright Tech's structured treatment programme — a calibrated sequence of high-purity chemicals applied in the correct order, at the correct dosage, to your pool's specific measured parameters.
Where standard pool contractors apply a generic chlorine dose and leave, Sparklear™ starts with a full water test, then applies a multi-stage treatment sequence covering sanitisation, water clarity, pH correction, alkalinity buffering, and algae prevention — all in a single visit.
Four Components.
One Standard.
Each Sparklear™ treatment applies all four components in sequence. Skip one and the outcome degrades. This is what separates a Sparklear™ visit from a standard pool service.
Hypochlorite
We use high-purity granular calcium hypochlorite rather than liquid sodium hypochlorite. At 65% available chlorine versus liquid's 10–12%, the dry form delivers more effective sanitisation per gram applied, with far less pH disruption — meaning fewer corrective chemicals are needed afterward.
Flocculant
Filtrex is a liquid flocculant that binds suspended fine particles — algae cells, dead organic matter, and colloidal cloudiness — into larger clumps that the filtration system can capture. Pools treated with Filtrex typically clear from turbid to crystal within 3–6 hours, visible to the naked eye.
Adjusters
Correct pH (7.2–7.8) and total alkalinity (80–120 ppm) are prerequisites for effective chlorination. Outside these ranges, even high doses of chlorine lose their sanitising power. We adjust pH and alkalinity before and after chlorination to ensure every chemical in the programme works at full effectiveness.
Algaecide
Chlorine alone cannot prevent algae re-growth between service visits. Our specialty algaecide is applied after sanitisation as a secondary biocide — eliminating existing algae cells and establishing a residual barrier that suppresses new growth until the next scheduled visit. It is the step most contractors skip.
Why the Difference
Matters
| Sparklear™By Bright Tech | Standard Contractor | |
|---|---|---|
| On-site water test before treatment | Yes | No |
| Chlorine form used | Dry Ca(OCl)₂ — 65% | Liquid NaOCl — 10–12% |
| Flocculant applied for water clarity | Yes | Rarely |
| pH & alkalinity corrected every visit | Yes | Only if visibly off |
| Algaecide applied as standard | Yes | No |
| Written service report every visit | Yes | Rarely |
| KKM compliance verified on-site | Yes | No |
| Staff training & operations manual | Yes | No |
| Typical clarity time post-treatment | 3–6 hours | 24–72 hours (variable) |
The Sparklear™
Recovery Timeline
From turbid to crystal-clear — here's exactly what your pool goes through, step by step.
KKM Compliance.
Every Sparklear™ treatment targets the exact water quality parameters published by Kementerian Kesihatan Malaysia (KKM) for public and semi-public swimming pools. Our specialists verify compliance on-site before leaving — not in a lab days later.
If post-treatment readings fall outside KKM specification, we remediate on the same visit. No additional charge. No follow-up scheduling. The pool is compliant before we leave.
KKM Compliance Details →On Your Pool.
Book a free first water test — we'll run the full analysis, show you exactly what your current chemistry looks like, and explain how we'd treat it. No obligation.